Well, I am finally nearing completion of my sausage curing cabinet build so I will start posting pictures.
Cabinet with door removed. Removed compressor, thermostat, and cooling coils.
Cooling will be achieved using a Black Cat DC PID controller and a 120 Watt thermoelectric cooling module.
Thermoelectric cooler will chill water that will be run through the radiator inside the cabinet. PWM controller will adjust fan speed on radiator fans.
Radiator fans will be running 100% of the time.
Heating will be achieved vis Black Cat AC PID controller running a 250 Watt PTC heater with an enclosed fan.
Humidity will be controlled using an Inkbird humidity controller which will run the humidifier and the purge fan.
Rust splotches will be cleaned when construction completed along with plugging and patching any holes.
Side Vent hole for one way air valve for purge function.
Top vent for one way air valve and purge fan
Purge fan
Heater, humidifier, and radiator in bottom of cabinet. Test fitting for best location.
1/2" holes drilled in cabinet top for cooling water tubes. Perfect fit.
Radiator mounted on 90 degree bracket that I picked up in Fleet Farm. Saved me the time to fabricate my own.
Radiator mounted
Cooling water tubes attached to radiator.
Rails test fit into cabinet. Clearance issue with door. Will have to make a cut in the door shelving.
Rails still need to be drilled for hooks and be cleaned and polished.
120 Watt cooling module