WSM therm port mod

Discussion in 'Charcoal Smokers' started by dirtsailor2003, Jul 3, 2015.

  1. dirtsailor2003

    dirtsailor2003 Smoking Guru OTBS Member

    A while back I ordered up the silicon therm ports that the new wsms come with to add to my Mini-WSM's and the 18.5. Since I need to use the 18.5 for tomorrow's smoke I finally decided I better put the thing in. So I got out the Makita drill, a 1/8" pilot bit Nd my 1 1/4" hole saw. My intention was to install one below the upper rack and one above the lower rack. Unfortunately I could only find one of the gaskets. So the other will have to wait. Glad I looked for the gaskets prior to drilling the holes! Not t much to look at but here's a few photos anyways.





    There she is all ready for ribs, chicken, and Dutch's wicked beans.
     
  2. dirtsailor2003

    dirtsailor2003 Smoking Guru OTBS Member

Share This Page