Converting Outdoor Stove to a Smoker

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

EPS

Newbie
Original poster
Aug 2, 2021
4
0
NH
I have just recently become active in smoking meats, using the offset smoker on my charcoal griller with success a few times this Summer.

My house was built in 1939 as a flophouse of sorts for the guys who harvested the ice blocks from the pond it overlooks. One of the most interesting leftovers of this history is a handmade outdoor stove. Not long after we bought the house a few years ago I dug out all the dirt (I think previous owners used it as a planter) and tried to use it to grill (unsuccessfully) or as a firepit (again unsuccessfully as it is too deep to get any heat at the top). Plenty of people have recommended that I convert it to a smoker, and maybe that's what it always has been. I picked up a few pieces of an old rusty smoker from the side of the road a few years ago. I am looking for suggestions or tips on how I can convert this into a meat smoker.
 

Attachments

  • 20210803_132053.jpg
    20210803_132053.jpg
    228.7 KB · Views: 52
  • 20210803_132100.jpg
    20210803_132100.jpg
    248.9 KB · Views: 54
  • 20210803_132106.jpg
    20210803_132106.jpg
    234 KB · Views: 53
  • 20210803_132111.jpg
    20210803_132111.jpg
    173.8 KB · Views: 53
Maybe it was part of an old whiskey still!
My first thought would be to place the barrel and cap on top, find the grates that fit the barrel OR use hooks to hang the meat inside the body tandoori style.
You could place the burning wood outside open door, leaned up against the opening.
 
What a treasure! I would place hardwood dowels across the top to hang meats from then just cover with a piece of metal roofing that could be slide slightly off center for ventilation (exhaust)
The fire would be made very small and tended to to maintain smoke and a little heat. Very neat set up for sure. Could make some fine bacon or sausages.
 
Looks like each ring is a little smaller as it goes down in... get accurate diameter measurements of each ring and have a grate made to fit each one... You can then stack them like a WSM or drum smoker... measure diameter on top and maybe a weber kettle cover/lid will sit on top ...
 
Thank you for all of the tips, everyone.

I've cleaned it up some and worked on some configurations with the old smoker parts that I have on hand.

As you can see, there is a gap between the smoker "insert" and the oven. Would a rope gasket like what is on my wood stove door work to fill that space?

Also, the insert is pretty rusty on the inside. Will that be a sanitary issue when I go to smoke some meat?

Thanks Again.
231126227_1190732351395011_6099960170642549165_n.jpg
233467402_875826243065481_1671320190086820974_n.jpg
232609584_1432465267111328_7477518815183787727_n.jpg
231420300_550876929447124_5784781920175766491_n.jpg
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Clicky