Stuffer Tube question

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

wnctracker

Meat Mopper
Original poster
Oct 24, 2016
152
32
Western North Carolina
Does anybody know if stuffer tubes are universal for all 5lb vertical stuffers? I have northern tool Kitchener and the plastic tubes have cracked. I’d like to replace them with stainless ones. Also, any drawbacks to stainless tubes? Thanks.
 
There’s not a universal tube that I’m aware of, and other than cost I see no drawbacks with Ss
 
The tubes are flared (have a flange) on the upstream end. The nut on stuffer can handle a slight change in the outside diameter of the flared end. Measure your tubes and check that dimension against the after market tubes you are buying.
 
  • Like
Reactions: indaswamp
The first source I checked had these for example, it says "Diameter at connecting point is 1-1/2". I'm sure other stores will show the dimension too.
 
  • Like
Reactions: indaswamp
The first source I checked had these for example, it says "Diameter at connecting point is 1-1/2". I'm sure other stores will show the dimension too.
Yep. I wenttto sausage maker and they were the same as what I needed. Was hoping to save money on eBay with a 3 pack but I really only do hog casing anyways. Thanks!!
 
I bought a few after market SS tubes. Most tubes that are 5 pound stuffers will work
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky