Smokehouse Way - Aka the new home of the X-Fire Gill and Copper Pot

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Had a couple really good weather days so knocked out a bunch of work…..

Ran all the electrical, did the build up on the columns and the today was able to get all the soffit up….Mrs Civil was a huge help holding each panel in place as it set the screws….i call today a leg day….i can’t even count the amount of up and down the ladder….the facial and drip edge on the sides is all that’s left on the roof work.
IMG_2822.jpeg

Just love the clean sleek look!!
IMG_2821.jpeg

Very pleased and you can see I’m ready for the panel and trim work on the posts!

So panel trim work then facing up the trusses!!!
 
The weather has been off and on so whenever the sun was shining I’ve been running outside to work……

Before Christmas was able to get all the facia and drip edge done…. Love the clean slick lines…..
IMG_2876.jpeg


After Christmas I was able to get the posts wrapped with siding and started fabricating the trusses….. doing a test fit tonight…still need to fab up the diagonal struts but I’m happy it fits!
IMG_2917.jpeg


Now that I have one fit the others will go much faster…. Fingers crossed tomorrow is a day of chopping and welding…….
 
  • Like
Reactions: BigW. and schlotz
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky