My wife bought me a 130B over the summer from a store that basically sells/auctions off Walmart and Amazon returned item pallets and stuff (yes, it's odd, and my wife is obsessed), but we were in between homes and didn't have the space to have it/use it until now. I was just trying to fire it up and as soon as I plug it in, I get an error. It'll stop after a couple seconds and I can turn it on, set the temp and time, and it'll start to heat up (I have a thermometer set up inside). After 3 or 4 minutes it'll error out and turn off. The display temperature never changes (currently reads 32 degrees). From my best guess, it's a bad temperature sensor.
The problem I'm running into is that I can't find ANYTHING on that sensor; no place to get one (other than directly from Masterbuilt), no directions on changing it. Nothing.
Does anyone have any information regarding this? I'm not against opening it up and trying to figure it out if I have to, but if someone has gone through this already and has some information on it, I'd greatly appreciate it.
The problem I'm running into is that I can't find ANYTHING on that sensor; no place to get one (other than directly from Masterbuilt), no directions on changing it. Nothing.
Does anyone have any information regarding this? I'm not against opening it up and trying to figure it out if I have to, but if someone has gone through this already and has some information on it, I'd greatly appreciate it.