I decided to start a thread about modifications for the Masterbuilt MES35B which is an analog (not digital) unit as there was very little information about modifying the unit to gain enough airflow to run the AMNPS unit. The stock unit only has a 7/16” exhaust hole in the back which will not be sufficient for running the AMNPS unit.
My upgrades include:
4” river country damper added to the top of the unit for exhaust.
A 3/8” bolt and nut plugging the existing exhaust hole.
A 2” river country dial thermometer replacing the standard stock door thermometer. If you want to get really fancy you can order a Telltru.
Opening up (drilling) the existing drain hole in the bottom of the unit to 3/4” and adding an additional four 1/4” holes around that drain hole for additional intake oxygen. This will ensure drippings only leak into the drip pan while bringing in enough fresh air to keep your AMNPS lit.
AMNPS runs like a champ on my unit with these mods!
My upgrades include:
4” river country damper added to the top of the unit for exhaust.
A 3/8” bolt and nut plugging the existing exhaust hole.
A 2” river country dial thermometer replacing the standard stock door thermometer. If you want to get really fancy you can order a Telltru.
Opening up (drilling) the existing drain hole in the bottom of the unit to 3/4” and adding an additional four 1/4” holes around that drain hole for additional intake oxygen. This will ensure drippings only leak into the drip pan while bringing in enough fresh air to keep your AMNPS lit.
AMNPS runs like a champ on my unit with these mods!