Water or no water?

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

moses

Meat Mopper
Original poster
Jul 26, 2013
203
12
Forest, MS.
I have always thought that putting water in the water pan provides moisture causing your meat to be juicier and less dry. Reading a few post here and there I might be wrong. What does the majority do, water or no water?
 
I did a first time cook on my WSM with no water and it turned out great. I have been reading up on Harry Woo from the Pitmasters and he like Myron is a higher temp cooked (275º) and uses no water in his WSM's so I gave it a try.
These were my first ribs on my new WSM by the way.

 
Last edited:
I have heard both opinions on the matter. I have always used water in my WSM. I think it also helps in maintaining the lower temps in my smoker too.
 
I have always used water in fear that my meat would dry out. I'll give no water a try next time or should I do no water and add sand?
 
I did a first time cook on my WSM with no water and it turned out great. I have been reading up on Harry Woo from the Pitmasters and he like Myron is a higher temp cooked (275º) and uses no water in his WSM's so I gave it a try.
These were my first ribs on my new WSM by the way.

 
I never use water in my MES 40 as I use a amazen pellet smoker, and the use of water in the water pan is not recommended, and I've had great results from everything I've cooked. I don't think it makes much difference in the quality of food, but using water does help your temps recover faster.
 
I have always used water in fear that my meat would dry out. I'll give no water a try next time or should I do no water and add sand?

The water acts as a heat sink. In other words it absorbs some of the energy from the fire and keeps the smoker from getting too hot. There's a lot of debate over whether or not the evaporated water moistens the meat. Personally , I don't think it does. I use a foil wrapped brick in my water pan (in my weber smoky mountain cooker) as a heat sink and this moderates the temp in the smoker and my meat still comes out nice and moist. But you do need the heat sink , so if you minus the water you gotta add the sand or brick or some kind of material to fill that need. Good luck.
 
Last edited:
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky