For those of you who are particular (anal
) about the placement of your holes on your UDS I submit this layout that I found on another forum.
For full size of 21.8" square resize it to 2093 pixels square. It doesn't really matter if the resolution gets grainy. You can still see the lines. I printed a copy on the plotter at work but I imagine if you have a Kinko's close by you could get them to print it for you. Cut out the circle and lay it on top of the drum and mark away.
Not really a big deal for dividing the drum into thirds but it is very helpful for the 8 lid holes if you go that way.
Dave
For full size of 21.8" square resize it to 2093 pixels square. It doesn't really matter if the resolution gets grainy. You can still see the lines. I printed a copy on the plotter at work but I imagine if you have a Kinko's close by you could get them to print it for you. Cut out the circle and lay it on top of the drum and mark away.
Not really a big deal for dividing the drum into thirds but it is very helpful for the 8 lid holes if you go that way.
Dave