Thanks for the add I'm rudy

Discussion in 'Roll Call' started by rudy, Aug 12, 2016.

  1. rudy

    rudy Newbie

    Wats up everybody my name is Rudy and I'm from Houston tx

    I recently got me an old air compressor it is 65" long and 20" wide it's a cylinder and I just needed some advice on how big my box should be I seen the calculators but didn't understand it yet, so any advice on how big the box should be and I want to cut two doors in my smoker so any advice on where to start the cut for the doors plz bc I was told it has to be 3" down from the top?? Idk but any more info on a beginner first build is appreciated any advice I'll take thanks everyone !!!!
     
  2. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

  3. mike5051

    mike5051 Master of the Pit SMF Premier Member

    Welcome to SMF Rudy!  Dave posted a great link, I want a RF now!

    Mike
     
  4. smokinal

    smokinal Smoking Guru Staff Member Moderator OTBS Member ★ Lifetime Premier ★

    Hi Rudy!

    [​IMG]   to the forum!

    Glad to have you with us!

    Al
     
  5. joe black

    joe black Master of the Pit OTBS Member

    Welcome from SC, Rudy. It's good to have you on this great site. There are some really fine folks here who are always eager to share their ideas, recipes and tips. All you have to do is ask and keep reading. I'm sorry but I'm not a builder, but the link above should head you in the right direction. Other folks should be around that can help you a lot.

    Good luck with your build and good smokin', Joe. :grilling_smilie:
     
  6. [​IMG]   Good morning and welcome to the forum, from a much needed rainy day here in East Texas, and the best site on the web. Lots of great people with tons of information on just about  everything.

     If you have trouble understanding any of the calculations just let us know , we will be glad to help, I am around most every day

    Gary
     
  7. rudy

    rudy Newbie

    Hey guys I have a question from the tutorial Dave sent to get the calculation for the volume of my tank do I get the length of the cylinder and not the ends? Bc it's 65" from side to side or am I suppose to get the length from the weld seams? Thanks everyone
     
  8. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    Measure the length from between the weld seam and the round end... Somewhere in there is close enough....  

     

Share This Page