Smoke stack For 250 gal RF smoker

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

smaloof

Fire Starter
Original poster
May 27, 2016
39
15
Georgia
Do you guys think this will work for smoke stack: STEEL ROUND PIPE 6-5/8" o.d. x 9-ga PIPE BALLARDS.I have been pricing out steel pipe and it is very expensive. I also don't want to waste money on something that is not thick enough and/or won't work well.
I would really appreciate your opinion.
 
Good morning smaloof.
I have 6-5/8" OD stainless pipe for mine with 1/8" wall. Your 9 ga is about .150 wall. Mine works really well. I would think this would work just fine no problems. Of course guys with multiple builds might be able to tell you advantages of it being thicker?
 
 I use #14 sheet metal and roll it.   Save your $ and buy some digital thermometers with the difference.

Heat loss on a smoke stack is minimal compared to the rest of the smoker
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky