setting the Maverick ET-73

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

johnny

Newbie
Original poster
Jan 7, 2007
5
10
Hi, just got a Maverick ET-73, and when I put in the Hi smoker temp at 220, then click Start/Stop, it goes right back to default of 176.. then I go to Lo temp, & put in 85 degrees, & clickon start?stop, it goes right back to the default of 50.. The same goes for setting the meat temp, no matter what numbers I put in, it defaults to 176.. What am I doing wrong???
Johnny
 
I'll have to check mine..why not come into chat and I can see whats happening.
 
Hi, thanks for your reply.. I just signed in as a new member, so will have to figure out how to get into Chat...
Johnny
 
Well i think I got this piece of technology figured out.. After setting my Hi & Lo temps, iwas clicking on the Start/Stop button, I accidentally clicked on the light?Mode button, and there it was.. I tried it several times to be sure that it would remember the settings, & it does.. Thanks, much,
Johnny
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky