Quick hardware question
- Thread starter nitrousinfected
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Should be fine as long as they haven't been galvanized. Keep in mind that the grade only deals with the hardening and tinsel strength, and has nothing to do with platings or coatings applied to the hardware.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Batten Down The Hatches!! Francine
- Started by indaswamp
- Replies: 51
- Blowing Smoke Around the Smoker.
-
Beer sales fall to 45 year low
- Started by Smokin Okie
- Replies: 33
- Beer & Ale
-
My first picana!
- Started by Brokenhandle
- Replies: 24
- Beef
-
Chamber Vac Sealer
- Started by Bigtank
- Replies: 22
- Slicers, Grinders, Tools, Equipment
-
A Blackstone Weekend
- Started by mcokevin
- Replies: 20
- Flat Top Griddles and Discada
