• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

Migration of the Bears

SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Bearcarver

Gone but not forgotten RIP
OTBS Member
Group Lead
Joined
Sep 12, 2009
Messages
45,243
Reaction score
18,197
Location
Macungie, PA
Migration of the Bears  (Final Refinishing)

I’m posting this for a couple reasons:
Some of you have asked if I would make Bears for you, and I refused because since my Heart & Lung problems got a lot worse 6 years ago, I can no longer Chainsaw Carve.
Also some have shown interest in getting some Chainsaw Carvings elsewhere.

So I figured I should post this to let you all know what you have to do to take care of them if you get a Chainsaw Carving.

Below you will see where I used to keep my Big Bears. Since they were always outside, they were exposed to Rain, Snow, and Sun. Since they were painted with a good Marine Varnish, the rain & snow isn’t too hard on them, but the UV Rays of the Sun really Kills them!!

So I’ve been scrubbing them with a Brush & Dish Soap every 2 or 3 years, and giving them 2 New Coats of Marine Varnish.
3 years ago, when I did them, I brought two of the small ones in my house. I put the Sitting “Buddha Bear” on the floor between the TV and the Pellet Stove, and the sleeping “Lazy Bear” on top of my Gun Cabinet, in my Living Room. This means I should never have to scrub & refinish them again.

This time I scrubbed the 3 Big Bears with a brush & Dish Soap. Like always, I had to start at the top & do a little at a time, and rinse it, so the soap doesn’t dry. Dried Soap would effect the Finishing Process. Also I had to use a step ladder to get the heads, because reaching up doesn’t work to good for me any more.

I was going to put the two smaller of the 3 Big Bears in my Pool Room, but Mrs Bear said nobody would see them there. She said put one on each side of the door in the garage that leads into our Living Room, which is the door everybody uses to enter our house.
That’s where I put them, and I’m hoping that since they’re out of the Weather & away from any Direct Sunlight, I might never have to scrub & Refinish them again!!!


So for those of you who are thinking about getting any Chainsaw Carvings, I would recommend that you find an area out of the Weather & Direct Sun, or be prepared to scrub them & refinish them every 2 or 3 years.


Bear




In case anyone here hasn’t seen all my Bears, Here’s a link to them & a Step by Step Showing How to Make them:

Link:     A Bear from Log to Finish

Lookout and 3 guards on duty.
This is the where they lived since their creation:





Scrubbing them good with Dish Soap, and a brush, & Rinsing real good:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1601.jpg.html




Applying 2 new coats of Marine Varnish on each Bear (Head to floor):
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1604.jpg.html




Two of them are now in their new Guard Position:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1613.jpg.html




Close-up of two Guards at the door leading to my Living Room. Their New Home:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1611.jpg.html




“Swampy” in his new Guard Position (Keeping an eye on my new Zero-Turn):
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1614.jpg.html




Swampy watching my “Cub”:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1615.jpg.html




Swampy with a Beer in his Paw:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1616.jpg.html
 
Last edited:
Nice !!!  I wish I could do that, An Artist and a great cook     
points.gif


Gary
 
Dang, all these Bears, I wish I had one

Gary
 
 
Migration of the Bears  (Final Refinishing)

I’m posting this for a couple reasons:
Some of you have asked if I would make Bears for you, and I refused because since my Heart & Lung problems got a lot worse 6 years ago, I can no longer Chainsaw Carve.
Also some have shown interest in getting some Chainsaw Carvings elsewhere.

So I figured I should post this to let you all know what you have to do to take care of them if you get a Chainsaw Carving.

Below you will see where I used to keep my Big Bears. Since they were always outside, they were exposed to Rain, Snow, and Sun. Since they were painted with a good Marine Varnish, the rain & snow isn’t too hard on them, but the UV Rays of the Sun really Kills them!!

So I’ve been scrubbing them with a Brush & Dish Soap every 2 or 3 years, and giving them 2 New Coats of Marine Varnish.
3 years ago, when I did them, I brought two of the small ones in my house. I put the Sitting “Buddha Bear” on the floor between the TV and the Pellet Stove, and the sleeping “Lazy Bear” on top of my Gun Cabinet, in my Living Room. This means I should never have to scrub & refinish them again.

This time I scrubbed the 3 Big Bears with a brush & Dish Soap. Like always, I had to start at the top & do a little at a time, and rinse it, so the soap doesn’t dry. Dried Soap would effect the Finishing Process. Also I had to use a step ladder to get the heads, because reaching up doesn’t work to good for me any more.

I was going to put the two smaller of the 3 Big Bears in my Pool Room, but Mrs Bear said nobody would see them there. She said put one on each side of the door in the garage that leads into our Living Room, which is the door everybody uses to enter our house.
That’s where I put them, and I’m hoping that since they’re out of the Weather & away from any Direct Sunlight, I might never have to scrub & Refinish them again!!!


So for those of you who are thinking about getting any Chainsaw Carvings, I would recommend that you find an area out of the Weather & Direct Sun, or be prepared to scrub them & refinish them every 2 or 3 years.


Bear




In case anyone here hasn’t seen all my Bears, Here’s a link to them & How to Make them:

A Bear from Log to Finish

Lookout and 3 guards on duty.
This is the where they lived since their creation:





Scrubbing them good with Dish Soap, and a brush, & Rinsing real good:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1601.jpg.html




Applying 2 new coats of Marine Varnish on each Bear (Head to floor):
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1604.jpg.html




Two of them are now in their new Guard Position:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1613.jpg.html




Close-up of two Guards at the door leading to my Living Room. Their New Home:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1611.jpg.html




“Swampy” in his new Guard Position (Keeping an eye on my new Zero-Turn):
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1614.jpg.html




Swampy watching my “Cub”:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1615.jpg.html




Swampy with a Beer in his Paw:
http://s836.photobucket.com/user/Bearcarver_2009/media/DSCN1616.jpg.html
I know I said this before,  Since you can't chain saw carve anymore, I think you should get a Dremmel  tool and do some Mini Bears
 
 
Nice !!!  I wish I could do that, An Artist and a great cook     
points.gif


Gary
Thank You Gary!!

And Thanks for the Point !!

You can do these---Just follow my Step by Step!!

But Just be Careful !!

Bear
 
First I would have to buy Another chain saw  The last two seemed to not find their way back home.

Gary
 
 
Bear

Thanks for the great info. My Bear needs a bath and this will help.  
points.gif


Larry. 
Thank You Larry!!

That Little Guy shouldn't take too much to wash & give a couple coats of Marine Varnish.

And Thanks for the Point.

Bear
 
Bear that is some real art work,master skills involved I hope you out weather them.

Richie

points.gif
 
Me too now, use to if they borrowed something and stayed at their house for a while  somehow it becomes theirs.   But not anymore like you Bear  they have better stuff than me.

Gary
 
Hey Bear I was thinking, If you need to adopt out any of your bears I have a perfect spot, and will take good care of it

Gary
 
 
Thanks Gary!!

Now if I can just find an envelope that will hold 600 pounds.
biggrin.gif


Bear
Naah  just load it in your truck and bring it when you come to use my smoker

Gary
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Back
Top
Clicky