Hi All. First post. Just setting up the MB 560 today. Did the initial burn off. Then sprayed the interior with canola. Did the second burn and the unit leaked out the rear end (the end by the hopper). It leaked in the front and back. I definitely sprayed too much oil into the interior. The unit also wasn't quite level. The right side (with the hopper) was about .5"-1" inch lower. I raised that side by about .25 inches.
Could the level issue be enough to cause the leakage? Or was perhaps the unit assembled incorrectly? Thanks much!
Could the level issue be enough to cause the leakage? Or was perhaps the unit assembled incorrectly? Thanks much!