Looking for advice on prepping the lid.

Discussion in 'UDS Builds' started by joshgrillinlawn, Dec 15, 2015.

  1. I'm in the planning stages of building a UDS, basically till I can afford the hardware, ie valves bolts etc.
    My question is how can I go about prepping the lid?
    It has a two inch bunghole and a smaller one (maybe an inch) that I figure I'll use as exhausts.
    My issue is prepping the lid. It's too big to fit inside the drum when I burn out the drum, so what's a good way to remove the paint off the lid? Also there is a rubber gasket, how would ya recommend I remove it?
    Thanks y'all.
    Josh.
     

Share This Page