Hot water heater conversion

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

dv242

Newbie
Original poster
Aug 22, 2015
20
18
Has anyone tried to convert a hot water heater into a smoker? I imagine they are very well insulated but I've never cut one open to see whats inside as far as room, or materials that may be harmful when heated. Anyone have experience with this?
 
They are glass lined (fiber glassed), I have built  a reverse smoker with two hot water tanks. The glass lining is epoxy which will "gas out" if elevated to the correct temperature. For expert guidance try approaching plumbing guys who might guide you in this. I once had  a similar doubt while DIY I contacted advanced plumbing http://www.advancedplumbing.ca/heating/ . Water heaters are thin sheet metal on  a glass tank. with insulation and glass tank away you need to reinforce the actual firebox.A hot water tank would make a good smoker. though it could be smaller than one can imagine.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky