Future Smokehouse Build

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

BGKYSmoker

Nepas OTBS #242
Original poster
Staff member
Moderator
OTBS Member
★ Lifetime Premier ★
Group Lead
Dec 25, 2010
14,364
12,482
Rineyville, KY
This is not my pic, found online.

Going to go with this type but with not as many bolts in the door support. From the looks of the bolts they are not SS. My hanger supports will have 2" holes drilled and they will be ripped so I have the same on both sides. My vents will be 3d printed, fresh air intake on the bottom and a 4" stove pipe with damper and cap for the outflow.

For the wood hope I have enough pallets, if not going with tongue & groove.

futsmkr1.jpg


futsmkr.jpg
 
This is not my pic, found online.

Going to go with this type but with not as many bolts in the door support. From the looks of the bolts they are not SS. My hanger supports will have 2" holes drilled and they will be ripped so I have the same on both sides. My vents will be 3d printed, fresh air intake on the bottom and a 4" stove pipe with damper and cap for the outflow.

For the wood hope I have enough pallets, if not going with tongue & groove.

View attachment 682584

View attachment 682583
I wonder what the reason was for excessive bolts in the door. I do like the size of the smoker.
 
  • Like
Reactions: JLeonard
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky