The #35 I picked up off ebay has a broken plate a munged up screw. Are there any mechaninc/machuinists here that can measure the threads on the end, that attach the plate? And the overall length, my screw won't reach the bottom. Wrong screw? The body mics 1.070, the plate threads are smaller. I'm a retired machinist, home shop now. I can make parts.
Enterprise stuffer- screw shaft-thread pitch?
- Thread starter Casebrew
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Power Out for last 4 days...
- Started by sandyut
- Replies: 27
- Blowing Smoke Around the Smoker.
-
Local To Your Area Recipe Thread?!
- Started by Rafter H BBQ
- Replies: 24
- Blowing Smoke Around the Smoker.
-
California Roll
- Started by Gonna Smoke
- Replies: 22
- ABT's and all things Appetizers
-
Is my bacon bad? Please help
- Started by hooked on smoke
- Replies: 22
- Bacon
