Detailed DIY smoke generator...

[dernektambura]

Hello everyone... this is detailed DIY smoke generator with assembly pics... all parts are electrical materials..
Parts and assembly:
1. RAB box 4" diameter
2. nipple assembled on to RAB box cover
3. stainless steel couplings and stainless steel pipe assembly
4. wire mesh inside pipe assembly
5. reducer and T assembly
6. venturi pipe and final assembly

 

[old sarge]

Sweet! How long does it produce smoke on one filling?

 

[GaryHibbert]

That's a good looking unit. Nice job.
Gary

 

[dernektambura]

One I made is 2.5" diameter, 12" long wood filled chamber....3/4 filled it lasts up to 1 1/2 hour.... if you use another 12 inch pipe and one extra coupling it can be extended to 24" and so on...now, also depends on small air pump air flow rate...as well as how many holes at the RAB box are open or closed. .

 

[gmc2003]

Nice looking generator. I see it getting allot of use in your future. Ingenious.

Point for sure
Chris

 

[dernektambura]

Nice looking generator. I see it getting allot of use in your future. Ingenious.

Point for sure
Chris

Already have two of them made... will install them attached to the side of my BBQs...

 

[SonnyE]

Well now, couple that up to your new Smokin It 3D and and start cold smokin it.

 

[dernektambura]

already tried with improvised setup on my egg ceramic bbq smoking cheese. .. works as planed... waiting for warmer temps to properly install..

 

[dernektambura]

Now. . who would think that small peace of sponge would create less smoke and lots of problems....tossed out piece of sponge filter and unit is at its full blast....

 

[indaswamp]

Nice build. can you show how you made the venturi in the 'T' for us?

 

[dernektambura]

Nice build. can you show how you made the venturi in the 'T' for us?

gotta break smoke processes to do that but I'll break a rule ... hold on sec...

 

[dernektambura]

 

[indaswamp]

Gotcha...Nice....