-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Welding OKJ Highland Seams
- Thread starter Stash Beardsley
- Start date
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Sounds tight and leak proof.
Might be an issue if you ever need to replace the firebox....
Might be an issue if you ever need to replace the firebox....
Stash Beardsley
Newbie
By the time the firebox burns out I'll be getting a handmade in the U.S. offset smoker. Worst case scenario, cutting disc and grinder. But I would definitely just upgrade the entire thing instead of sinking money into this one.
Nice job, I wish I had a shop like that!
Al
Al
I did the same to my OK Joe. And I have a Hobart welder too! Great job!
Stash Beardsley
Newbie
Was wondering if anybody else had done this too. Noice.
golfpro2301
Smoking Fanatic
I partial welded my longhorn reverse flow and added RTV. In process of welding top lid shut and installing yoder door on side. Will then insulate box with a 55gal drum or sheets of SS
like you this is to get me through this year until I start my Outlaw Patio Clone in a few months
like you this is to get me through this year until I start my Outlaw Patio Clone in a few months
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
- Featured
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
