Welding OKJ Highland Seams
- Thread starter Stash Beardsley
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Sounds tight and leak proof.
Might be an issue if you ever need to replace the firebox....
Might be an issue if you ever need to replace the firebox....
By the time the firebox burns out I'll be getting a handmade in the U.S. offset smoker. Worst case scenario, cutting disc and grinder. But I would definitely just upgrade the entire thing instead of sinking money into this one.
I did the same to my OK Joe. And I have a Hobart welder too! Great job!
golfpro2301
Smoking Fanatic
I partial welded my longhorn reverse flow and added RTV. In process of welding top lid shut and installing yoder door on side. Will then insulate box with a 55gal drum or sheets of SS
like you this is to get me through this year until I start my Outlaw Patio Clone in a few months
like you this is to get me through this year until I start my Outlaw Patio Clone in a few months
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Painting Vinyl and Aluminum
- Started by Gonna Smoke
- Replies: 34
- Blowing Smoke Around the Smoker.
-
Recommend Outdoor Propane Fryer?
- Started by Count Porcula
- Replies: 33
- General Discussion
-
Featured Smoked Chuck with a braise finish
