SW Pa

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

metikki

Newbie
Original poster
Nov 9, 2013
5
10
Dale from Latrobe Pa here! Thanks for the welcome! I've been a lurker for some time but I was given an operational food warmer from a hospital. It was an older model but needed new door gaskets so I put on the rope seals and added a 3" vent. I plan on using a double burner system because the warmer can still be used to warm foods, as we have a big family during the holidays

I am an avid bowhunter and a rep for the state org. I purchased a side of black angus beef this summer that never saw a pasture and was fed 2nd cut alfalfa. I killed a black bear during the early season in Pa and followed it up with an 11pt buck in October.

I'm looking for ideas for my smoker to get it going properly. I would like to keep the warmer capabilities intact and most likely will make jerky using the warmer.

Nice to be here formally!!

Best wishes!

Dale Hajas

Metikki
 
[h1]
texas.gif
Hello and welcome from East Texas. This is a great site, lots of information and great people that are willing to throw in their two cents worth on about anything.   
[/h1][h1]  [/h1][h1]Gary[/h1]
 
Welcome Met
You will find plenty of friendly folks with great advice on this forum. Lt the search bar at the top of the page be your new friend. There are over 1 million post on this forum. And that a lot of powerful knowledge right at your finger tips. Or just ask! If you have not checked it out already, Give Jeff's 5 day ecourse a try. It is free and full of great information to make you an even better smoker.
Again Welcome.
Brian
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky