Hello,
I have been having issues with my smoker for the passed year I believe my issue lies with the circuit board. I have changed out my digital control and replaced the element both parts from
Masterbuilt. I am trying to buy the circuit board part#9907140048 but
Masterbuilt and Appliance Factory Parts do not have them anymore. I currently stuck right now with a fairly new smoker and its not working :(. I believe the relay on my circuit board is bad but you never know. I can attached a picture of my circuit board as there may have been a small spark or fire along with the board getting slightly wet!
Any help is appreciated!!!!
thank you
Hi there and welcome!
I'm not sure you will be able to find an exact replacement board for your smoker. You could gamble and try a different part for an MES like yours and hope it works but I wouldnt bet on it.
Now there IS an option that a number of us guys have applied and honestly makes your smoker 100X better than it ever was brand new.
The option is to do a simple rewire (yours is likely even simpler than my guide mentions) and to then use the $150 Auber PID plug and play controller.
Now you might ask "Why would I pay $150 when that is close to the cost of a new smoker?". My answer is that for $150 you get the Auber PID and
you get a better than new smoker!!!
These Auber PID controllers allow your smoker to hold within 1-3 degrees of your set temp. They are super precise when dialed in! No more temp swings! You can now do bacon and sausage without fear of temp swings melting out the fat! You now get a consistent even temp rather than an average temp! The conversion to use a PID makes your smoker live sooo much longer since it is a way simpler machine than with all that crappy circuitry
Masterbuilt has in the mix!
Your rewire would be to take one of the braided red wires still in the smoker (that connected to the braided red wires in your picture) and connect it to the smooth black wire still in the smoker (not the smooth black wire in your picture).
You then take the other braided red in your smoker and connect it to the smooth white wire in your smoker (neither of the red braided or smooth white wires in your picture).
This now makes the MES plug feed power to the heating element WITH the over heating safety switch in the mix!
With this rewire u plug the MES into the Auber PID. You plug the Auber PID into the wall socket. You clip the Auber PID temp probe to one of your smoker racks and punch in a set temp.
The PID will now feed power to the MES heating element to hit and hold your set temp. Boom, done!
My post here covers all of the details but that is the short of it all:
Lately I've seen a number of posts about guys wanting to rewire their MES. I had wanted to post a quick and simple guide for those out there that are curious or those that simply need to rewire but need a little assistance. Well here goes. Disclaimer: When messing with electrical equipment...
www.smokingmeatforums.com
Honestly man everyone who does the rewire and moves to a PID controller says the same thing. They say "I wish I would have done this sooner, this smoker is now amazing!"
One minor drawback, but not really... is that you will have to use the A-Maze-N Pellet Smoker (
AMNPS) tray or tube and pellets to now generate smoke. Most of us did that anyways and its a drastic improvement over feeding chips so not really a drawback lol.
I hope this info helps and ask all the questions you have :)