Smoke Box Door (Wood loader)

[sheltbt]

 I have a problem with it. On the chip loader it does not strop turning when it dumps the chips. And also you can pull it out without turning it to unlock. The tabs seem to be straight. What can I do to remedy this?

Thx in aadvance

 

[SmokinAl]

I wouldn't worry about it. It's not going to fall out, and after you dump the chips, just leave it in that position. Or you could do like most MES guys do & buy an AMNPS. 

http://www.amazenproducts.com/

Al

 

[sheltbt]

Thx, yes I have already bought the AMNPS. I didn't figure it was a problem. Thx again