I have been running some experiments on my new Oklahoma Joe's bronco to try and get long burns at lower temps for doing smoked sausage. My goal was to keep temps stable below 170 but to ideally be able to start at 130 or so and creep up to the 170ish mark. I previously had tries the snake method on the bronco for a couple hours and it seemed to be going well so this weekend I decided to start early and shoot for 10 hours or more. All I did was set up the snake with royal oak briquettes and no wood. No food, just a dry run.
So, here's where I need some expert opinions. This method worked so well with temp control and I got the 10 hours with more to left to burn. I was able to start at 135ish and was able to slowly climb to 170 with minimal fluctuations. all seemed well and was happy. But, with no wood, the briquettes gave off continuous thin blue smoke. With all that said, are my temps too low for the charcoal to preheat enough as the snake burns to keep me on good quality smoke or will the smoke that's given off by the briquettes end up being bad smoke? Looking for opinions before I go all in with some sausage this next weekend. Thoughts?
So, here's where I need some expert opinions. This method worked so well with temp control and I got the 10 hours with more to left to burn. I was able to start at 135ish and was able to slowly climb to 170 with minimal fluctuations. all seemed well and was happy. But, with no wood, the briquettes gave off continuous thin blue smoke. With all that said, are my temps too low for the charcoal to preheat enough as the snake burns to keep me on good quality smoke or will the smoke that's given off by the briquettes end up being bad smoke? Looking for opinions before I go all in with some sausage this next weekend. Thoughts?