Plug and Play PID HELP needed!!

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

rpeters48

Newbie
Original poster
Jan 5, 2014
26
10
Raleigh, NC
So I just received my Auber Dual probe PID controller for my Bradley digital smoker. I set it up to do my first pulled pork for the super bowl but having issues. I hooked it all up and had it set for 220, probe looked like it was reading temp right and slowly climbing for the pre heat, went inside a bit and heard the alarm going off which I set to 280, it was still showing that it was powering the heater while this was happening, I opened the door to cool it down but would never stop showing High alarm. Now it will only display H as if its not hooked up. Is this just a bad probe? I swapped the probes and the meat one reads fine. Tried hooking it up for just a smoker temp to at least control that with the one probe but wont turn on the heating element. Any help would be much appreciated.

Thanks

Rick
 
Last edited:
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Clicky