One of the mods I did with my former propane grill was to build an oven attachment. I like the look of a traditional open pizza/bread oven and tried to mimic, within my skill set. I used some sheet aluminum and riveted some piano hinge to make two hinged sections. I flush riveted 29 Canadian pennies to the opening. That gave the attachment some real value, $0.29CAD or $0.23US. This attachment was easily installed and removed and was stored in the storage below the BBQ when not in use.
Installed on the BBQ, the lid overlaps and makes a good seal.
I added a motor and fan to attempt some air movement. It's a cheap shaded pole motor, insulated from the BBQ to avoid a 110V surprise. I added a dollar store stainless steel bowl to the lid to keep the motor covered during use.
With a smoke box smoking, and the heat on high, I turned out homemade bagels, nachos and pizza. I started with a pizza stone on the floor and moved on to quarry tile that covered the entire grill.
Installed on the BBQ, the lid overlaps and makes a good seal.
I added a motor and fan to attempt some air movement. It's a cheap shaded pole motor, insulated from the BBQ to avoid a 110V surprise. I added a dollar store stainless steel bowl to the lid to keep the motor covered during use.
With a smoke box smoking, and the heat on high, I turned out homemade bagels, nachos and pizza. I started with a pizza stone on the floor and moved on to quarry tile that covered the entire grill.
Last edited:
