So I got a ET-732 from Todd and I go to set it up for use tomorrow. Read the instructions, OK, no big deal. Install the batteries in order to to a boiling water calibration test.
Turn the receiver on, go to turn the transmitter on/off and I get nothing. It will neither turn off, nor re-sync.
All it comes up with is either all 8's (888) and all the various symbols show up, or just 88 or the 3 dashes (- - -) in no particular order.
Pull the batteries, install different ones, same thing.
Can't turn it off, can't get any reading whatsoever in the boiling water test, nothing, nada.
Is it DOA? (not really going to be a happy camper if it is, as I bought it to replace a Taylor unit that actually works)
Turn the receiver on, go to turn the transmitter on/off and I get nothing. It will neither turn off, nor re-sync.
All it comes up with is either all 8's (888) and all the various symbols show up, or just 88 or the 3 dashes (- - -) in no particular order.
Pull the batteries, install different ones, same thing.
Can't turn it off, can't get any reading whatsoever in the boiling water test, nothing, nada.
Is it DOA? (not really going to be a happy camper if it is, as I bought it to replace a Taylor unit that actually works)