Just started using my Master Forge vertical propane smoker again. I smoked some spare ribs today, and bunch of brats. Everything came out decent, but felt like I was constantly adjusting the propane/flame to maintain temp at about 225 - 250. Only mod to the smoker is a gasket for the door that I installed when I 1st bought it. Should I expect more consistent temperatures with this smoker, or is this as good as it gets?
Master Forge Smoker
- Thread starter Umpqua
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Not sure what the chip/chunk pan looks like on yours.....But, you can be getting a flare from there that is making your temps jump. Post a pick of the inside of your smoker and we'll see what can help you with.
Jim
Jim
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
The sound of a generator
- Started by pc farmer
- Replies: 26
- Blowing Smoke Around the Smoker.
-
Good News Day! Walking with both shoes!!
- Started by sandyut
- Replies: 25
- Blowing Smoke Around the Smoker.
-
Finally went feeshin!!
- Started by Timber II
- Replies: 24
- Blowing Smoke Around the Smoker.
-
Struck gold (again)
- Started by Operator
- Replies: 20
- Wood Smokers
-
Propane grill recommendations
- Started by PolishDeli
- Replies: 19
- Propane Smokers
