Jacard Purchase?

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

foamheart

Gone but not forgotten. RIP
Original poster
OTBS Member
http://www.jaccard.com/Meat-Maximizer-Meat-Tenderizer--45-Knife-Stainless-Columns_p_15.html

Anyone have any experience with these products? I have wanted one a long time but just never hit me at the right time.

They make many types, I saw this one has plenty of blades and SS tubes whatever that is. Its the Tim "The Toolman" Taylor in me that says stainless steel good in good !

So has any one had good/bad experience? Does it in fact tenderize? Is the Jaccard the best Jaccard?

I am thinking it would be good for chicken fried steak, or maybe even deep brine/curing like for a ham or corned beef pastrami?

Anyone have an opinion?
 
The Jaccard is a decent purchace for getting the job done. It is a little hard to clean because the needles are so close together. A good spray

with a hose is probably the best way to get the thing clean. I have 2 of them.  We usually cut up 3 loins at a time for pork chop sandwiches at my business, and the Jaccard was a lot of work for that many at a time.  I ended up buying a "Kitchener" tenderizer at Harbor Freight a few years back.  This thing works pretty good. (Hand crank) I don't see them listed there anymore.  Northern Tool has them,  and they are more expensive!

The Jaccard is great for getting a marinade to penetrate the meat, and does tenderize it.

I hope I helped.

Dave
 
Hi Foamheart,

I've had one for years. It is good for chicken fried steak and also reg. steak cuts. I do it with venison steaks all the time. Just don't over do it or it will taste like someone chewed it before you. I usually cut the steak about 1/2 in. thicker then I want to cook, pass the jaccard over never doing the same spot twice. Flip and do again. That thins the cut of the extra 1/2 in. Get bbq grill screaming hot, brush steak lightly with evoo and sear and cook to rare or med rare. I haven't bought a beef steak in 30 yrs. Just watch cooking time because extra surface area caused by multiple punctures causes meat to cook faster then normal. I do also use it to puncture meat I am brining, wet or dry to insure cure penetration. 
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky