This weekend I plan on cutting my CC door out and have a few questions before I do. #1, on the 2 sides of the door,, Iv seen post where they were pre bent to fit the sides. I have also read that you can use clamps to hold them down then weld them. I don't think that I feel comfortable trying to bend them to fit,,, And it seems that if you clamp them down and weld them they will have a little spring left and might flex the door. I plan on doing a "blind weld" (I think that's what its called) on them so could I tack them at the top and clamp them down but once their clamped heat them up with map gas to try to get them to hold the shape a little better? And #2,, I have read to cut the door out but leave the 4 corners until you get the strips on. If you put the strips on,,, how do you finish cutting the corners? Am I missing something?
Thanks
Spooky