I need help with Auber syl-2362 fast

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

ryans01z28

Smoke Blower
Original poster
Apr 5, 2013
98
10
I switched my PID controller In the middle of a run and I need help setting it up I have never used this type of pid before. I always had a MYPIN pid. I need help setting it up fast. I need to know how to set up the offset on it. Right now I have my temperature probe in Ice water and it is reading 54.8°
 
I may not be helping but the Auber WS-1510ELPM PID I have it describes that if you are doing an ice water test and it reads 2°C you need to set your offset to 2 to get the display to read zero. So I guess subtract 32°F from your ice water number and enter that difference as your offset to get the display to read 32°F. My sensor is right on so my offset is set at the default 0.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky