• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

Finally Done

deere317

Newbie
8
10
Joined Sep 13, 2016
It took longer than I though but here it is fellas
 
Last edited:

SmokinAl

SMF Hall of Fame Pitmaster
Staff member
Moderator
OTBS Member
★ Lifetime Premier ★
44,599
6,279
Joined Jun 22, 2009
That's really a nice smoker!

I wish the bottom rack on my Lang pulled out like yours does!

Al
 

JckDanls 07

Smoking Guru
OTBS Member
Group Lead
5,693
475
Joined Sep 10, 2011
Thumbs Up ... excellent build... question on the exhaust stack ... Is the square tubing cut to the arch of the round end or is it still square and inserted through a slot cut in the bell end ?? and then what ever size hole cut in the tubing for proper size vent ?? `
 

deere317

Newbie
8
10
Joined Sep 13, 2016
I cut the end of the tank bell from the top of the tank to the top of the firebox. I can't remember off hand what size opening I cut in the square stock for the flue but it was whatever the smoker calculator suggested. There's a few things left to do on the build I have to weld a front handle on come up with some sort of chimney damper and fabricate a swing out workstation/ counter
 

Hot Threads

Top Bottom
  AdBlock Detected

We noticed that you're using an ad-blocker, which could block some critical website features. For the best possible site experience please take a moment to disable your AdBlocker.