Everything taste like a camp fire

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
At the risk of sounding like a girl 🤦‍♀️......why do u have those metal U bolts (?) on there? Where in the electric smoker would u put that?
The lighted box is the Auber PID controller. It keeps temperatures within 1-5° of set temp, unlike the Masterbuilt controllers.

The U-bolts are just to keep it standing up for better airflow. The front one is really the only one needed. Before the mailbox mod, I just place in bottom of smoker opposite the element/ chip holder.
 
  • Like
Reactions: Dwayne&Heidi
Lot of MES owners have done the bypass and installed the PID controller to keep from the huge temp swings. Stock controller will swing temps probably 15° both ways as element kicks on and off. Just keeps temps closer to set point.
Can check it out here
 
  • Like
Reactions: Dwayne&Heidi
Older thread but another good read of different thoughts.
 
Do u put the tray /tube inside the MES?
I use the tray for mes with the mailbox I haven't tried the tube but some people say it puts off to much smoke for inside the mes , others use the tube with dust instead of pellets and say it's fine, will say tubes will burn better in low oxygen environments. I use the tube in my pellet grill where the tray wont stay lit.
 
  • Like
Reactions: Dwayne&Heidi
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky