Another MES 40 Gen 2 Victim

[Winterrider]

Kurt, when the time comes bottom white & tan together, and black & tan that are both into relay together correct? Should those 2 connectors be pulled from relay after cut or they will be dead anyhow ?

 

[tallbm]

@Winterrider I've sent you a PM with lots of text info but here here is a good image for a good visual. Once you have the proper wires identified it is as simple as the image indicates to rewire for a PID.

NOW, if you want to do a superb job you would replace the connectors on the heating element and the connectors on the safety rollout limit switch with hi-temp stainless steel ones because the crappy connectors MB uses are probably corroding on you right now and are the the other major failure point of an MES. BUT, this isn't mandatory to get you up and running with a an Auber Plug and Play PID controller :)