I have searched the forum for answers to using the AMNS Tube Smoker but I can't find an answer for my smoker nor can I get this thing to work no matter what I do. My smoker is has a single propane burner that burns the length of the smoker. I bought the tube smoker in order to get some smoke but no matter where I put it I can't get any smoke once I light the burner. I had another burner made so that I can cook by indirect heat, with the flame only going half way across the length of the chamber, also with the mind set
that if I place the Tube smoker on the side where there is no flame and align it right up under the exhaust tube I would get smoke and that didn't work. I can place my tube smoker under the flame, over the flame, under the grate but it goes out the minute the chamber heats up. Should I start drilling holes in my smoker or is my only solution the mailbox mod. I'm trying to determine if I have a two way issue. 1) the heat is consuming the smoke or 2) lack of airflow. I usually cook between 225 and 250 degrees. Any suggestions would be highly appreciated.
thank you
View media item 427227
that if I place the Tube smoker on the side where there is no flame and align it right up under the exhaust tube I would get smoke and that didn't work. I can place my tube smoker under the flame, over the flame, under the grate but it goes out the minute the chamber heats up. Should I start drilling holes in my smoker or is my only solution the mailbox mod. I'm trying to determine if I have a two way issue. 1) the heat is consuming the smoke or 2) lack of airflow. I usually cook between 225 and 250 degrees. Any suggestions would be highly appreciated.
thank you
View media item 427227