jeep
Newbie
- Jul 12, 2015
- 4
- 10
I have a masterbuilt PRO smoker. I can't keep the temp any lower then 300. How do I get it down and keep it down. I use a cast iron pan now.... And I got a low flow regulater but still not working.... What can I do?
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Temp.
- Thread starter jeep
- Start date
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
I had the same problem,Jeep. What I came up with is leaving the top door open a little bit. Sounds inefficient but works. With mine about 1\2inch keeps 240 degrees. I wondered why the latch was adjustable!
bmaddox
Master of the Pit
Have you tried adding a needle valve so you can turn the gas flow way down?
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
