Smokehouse Build #2

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

BGKYSmoker

Nepas OTBS #242
Original poster
Staff member
Moderator
OTBS Member
★ Lifetime Premier ★
Group Lead
Dec 25, 2010
14,424
12,689
Rineyville, KY
Just a rough form here for the KY smokehouse.

Not going the same as I did with the PA smokehouse and building as I go.
This is a 2x6 form, going to lay some gravel down, little rebar then pour redicrete. Nix the stove pipe idea for cold smoke.
The pipe behind I dont know what it was for, son in law dont know either. So what I'm going to do is use it to put a pipe clamp around it and secure to back of smokehouse.

IMG_4238.JPG
 
Nice start.
Too far away to offer you some 6x6 wire rebar from a curb find roll. (I use it to make tomato cages.)

Pipe?
Call 811 to verify what is below. Are you in HOA development?
 
  • Like
Reactions: HalfSmoked
Nice start.
Too far away to offer you some 6x6 wire rebar from a curb find roll. (I use it to make tomato cages.)

Pipe?
Call 811 to verify what is below. Are you in HOA development?
No need to call 811
No HOA around here, no cable tv, had to get (dish), no internet (hughesnet)

homesh1.jpg
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky