Should I put a dam...

[inkjunkie]

On the RF plate on the low side? I have a piece of angle iron between the 2 halves of the plate. The plates are angled from the sides into the angle iron....the angle iron then drains into a piece of 1.5" pipe which exits the bottom of the CC. Thinking I may weld some angle iron onto the drain ends of the RF plate...just in case...sorry if this is confusing....

 

[daveomak]

You could put up a flat bar dam .... tack in place about 1/2" before the end of the RF plate... Be sure to allow for grease to pass....

RF DRAIN.jpg

• daveomak
• Sep 5, 2015

 

[inkjunkie]

You could put up a flat bar dam .... tack in place about 1/2" before the end of the RF plate... Be sure to allow for grease to pass....

RF DRAIN.jpg

• daveomak
• Sep 5, 2015

Thank You Sir. The way you suggested is a bit over my patience level...I took the easy way out and just welded some angle iron to the plates....

20150906_202038.jpg

• inkjunkie
• Sep 6, 2015

 

[inkjunkie]

It is up on wheels....

20150906_151427.jpg

• inkjunkie
• Sep 6, 2015