Should I put a dam...

Discussion in 'Reverse Flow' started by inkjunkie, Sep 5, 2015.

  1. inkjunkie

    inkjunkie Master of the Pit

    On the RF plate on the low side? I have a piece of angle iron between the 2 halves of the plate. The plates are angled from the sides into the angle iron....the angle iron then drains into a piece of 1.5" pipe which exits the bottom of the CC. Thinking I may weld some angle iron onto the drain ends of the RF plate...just in case...sorry if this is confusing....
     
  2. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    You could put up a flat bar dam .... tack in place about 1/2" before the end of the RF plate... Be sure to allow for grease to pass....

     
  3. inkjunkie

    inkjunkie Master of the Pit

    Thank You Sir. The way you suggested is a bit over my patience level...I took the easy way out and just welded some angle iron to the plates....
     
  4. inkjunkie

    inkjunkie Master of the Pit

    It is up on wheels....
     

Share This Page