pastrami brine troubleshooting

[arqkay]

Hoping someone can help or have some advice...

I made a recipe for pastrami with an equilibrium brine... 4130g/9.5lb brisket (i separated the point and flat) and 10L of water with 1.5% salt (214g) and 0.25% Prague#1 (35g). I let it sit for 9 days.. maybe I should have done 5?... washed it well (or so i thought) but didn't soak it in clean water then smoked it long. Came out quite salty. This is an equilibrium brine, so I wouldn't have expected it to come out as salty.

While It's probably not inedible level of salt with toppings and such, I'm wondering if the meat absorbed too much salt (nacl) then maybe it absorbed too much Prague powder such that I shouldn't eat it? ... even though it's a equilibrium brine, something must be up; I know my scale work fine :)

 

[Fueling Around]

Welcome to SMF
Stop over at Roll Call when you get the chance.

Roll Call

This is where all new members should begin. Tell us a little about yourself, where you live, what you do, etc. Just helps us get to know you better;-)

www.smokingmeatforums.com

Your numbers work out for meat, water, salt and cure for a 1.75% salt brine.
Remember cure #1 is basically all salt so we add that number to the salt percentage.
Equilibrium is not a method to control salt by number of days. Gradient is controlling salt by the time factor.
With equilibrium you determine the total salt up front. Many add sugars to soften the bitterness of the salt.
I would double check your scales. I use a larger scale for meat and a 50g scale for salt, cure, and spices.
10 days is the minimum I would go myself. It is perfectly safe to eat even if salty to your taste.
You can soak meat slices in water to leach out some salt, but it will also take away some flavor.

Hope this helps.

 

[arqkay]

Thanks John; yes makes sense since it's the concentration controlling the max salt levels assuming the solution stays well mixed which it should. ppg should about 156 ppm...

I did use ice in the beginning which took a several days to melt at my keizer temps, so I was wondering if it maybe over salted first since the concentration would have been higher due to the ice. Perhaps next time I also try to melt most of the ice sooner or leave it out of the fridge longer. Will probably go less nacl next time and maybe next, next time, a final clean soak if needed.

For scales I'm using a 55lb postage scale with 0.5 accuracy for the big stuff and a turin espresso for the smaller stuff, also have a variety of jeweler and other scales for coffee and brewing on hand thanks to my other hobbies :)

 

[SmokinEdge]

I did use ice in the beginning which took a several days to melt at my keizer temps, so I was wondering if it maybe over salted first since the concentration would have been higher due to the ice. Perhaps next time I also try to melt most of the ice sooner or leave it out of the fridge longer. Will probably go less nacl next time and maybe next, next time, a final clean soak if needed.

This may well be the problem. If you weighed out water weight in ice alone then applied the salt and cure as “equilibrium “ that won’t work. The salt and cure must be dissolved in the water first. If you want to add some ice after that’s fine but you cannot start out with pure ice.