I have a MES 40 I purchased two years ago from SAMS. So far I have replaced the Temp probe, the chip loader and larger chip tray. On the last smoke doing pork butts I put them on at 10:00pm and when I woke up the next morning the digital readout showed everything still working but upon opening the unit I find not heat inside. I find the heading element lead was fried on one side of the element.
Masterbuilt sent me a new element. I put it back on but now I find I can not adjust either temp or Time. Can anyone give me direction. ?
Thanks in advance
Masterbuilt sent me a new element. I put it back on but now I find I can not adjust either temp or Time. Can anyone give me direction. ?
Thanks in advance