Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
I have a gen two MES. I added chips to it for the first time. Let it smoke down and the next time I tried to add more chips the chip holder was difficult to insert and would not twist to empty. Any ideas why or how to correct it?
Nope, not too many chips. I did look in it this am. It is scraping metal to metal in the rear where end of chip loader goes. Strange to me it was smooth as silk . After I had it curing for the initial smoke up it seemed the metal warped.