Toggle sidebar

Back panel of MES30

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Remove the Ads for LIFE - 50% Off!
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
mooch91

mooch91

Newbie
Original poster
Oct 28, 2014
23
15
Has anyone experienced the back panel warping on their MES30? If so, what did you do about it?

I had mine off for component replacement and now is the time to straighten it out before screwing it down.

Thanks!

A61EB03A-B358-420A-A566-187DC6592DF6.jpeg
 
Perhaps a brace diagonally across it with some angle aluminum or some that you can rivet on? Just throwing out an idea as I am not familiar with it.
 
You must log in or register to reply here.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Similar threads

I
MES 40 Digital Rebuild
Replies
18
Views
3K
Electric Smokers
ianmkane1
I
S
MES30 Digital No Heat
Replies
1
Views
843
Electric Smokers
river100
river100
J
MES30 reading much higher than Smoke X
Replies
9
Views
1K
Electric Smokers
tallbm
tallbm
SmokingUPnorth
Kettle vent handle melted.
Replies
5
Views
334
Blowing Smoke Around the Smoker.
chopsaw
chopsaw
F
MES 30 model 20071914 over heating
Replies
11
Views
1K
Electric Smokers
dr k
dr k
fishingaddict
Old MBES control
Replies
2
Views
1K
Electric Smokers
tallbm
tallbm
4
Troubleshooting MES 30 MB20071117
Replies
10
Views
611
Electric Smokers
geostriata
G
R
"Time" button on my 40" digital electric smoker not workin so it wont power on
Replies
8
Views
2K
Electric Smokers
70sdiver
7

Latest posts

Hot Threads

Top Bottom
Back
Clicky