The time set button on the cntrl panel has been a Lil bit reluctant bout responding to finger presses and has now decided to quit responding entirely. I've tried Gentle and rough, various sides etc. Have unplugged fer a minute several times to no avail.
Now the temp set button is showing signs of Goin down the same path.
Read about a PID upgrade but saw the $150 cost which is a little outta my reach @the moment, car went tits-up and I'm on a "fixed income" i.e. poor.
Took the two screws off the back of the controller before I was interrupted; honey, could you..., discovered that I'll hafta take sumthin else apart to disconnect it.
Sorry, I do tend to ramble,
My question to y'all is:
Anyone have probs with the buttons on the cntrl unit?
Any solutions, is it fixable w/out replacing/ upgrading? Work around(s)?
Thanx Fer takin the time to read and, hopefully, respond.
Thanx agin
Take care
Roger
p.s. is this the correct forum for this type of post?
Now the temp set button is showing signs of Goin down the same path.
Read about a PID upgrade but saw the $150 cost which is a little outta my reach @the moment, car went tits-up and I'm on a "fixed income" i.e. poor.
Took the two screws off the back of the controller before I was interrupted; honey, could you..., discovered that I'll hafta take sumthin else apart to disconnect it.
Sorry, I do tend to ramble,
My question to y'all is:
Anyone have probs with the buttons on the cntrl unit?
Any solutions, is it fixable w/out replacing/ upgrading? Work around(s)?
Thanx Fer takin the time to read and, hopefully, respond.
Thanx agin
Take care
Roger
p.s. is this the correct forum for this type of post?