Another 3D print

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

BGKYSmoker

Nepas OTBS #242
Original poster
Staff member
Moderator
OTBS Member
★ Lifetime Premier ★
Group Lead
Dec 25, 2010
14,235
12,061
Rineyville, KY
Printing a wall mount for one of my AR. Using petg and 90% infill.
Slide onto the mount into the mag well. The mag release button will snap into the mount. Going behind my toob. Once the mount is secured to the wall it will hold 100 lbs.

arwall.JPG


My printers. The one in middle is down getting a new fan install.
IMG_8144.JPG
 
Well had a brain cramp with the AR wall mount and ran out of filament sometime during the night.

So last night I started another with a full spool..
Went a light bone color.

Gotta do some touch up still. The slot is where the mag release locks in the mount.

arwall3.JPG


arwall4.JPG
 
That's cool and looks like quite a collection of printers
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky