Hey everyone,
I’ve been reading this forum for the past few months and it has helped me dial in my MES 40. I smoke a lot of summer sausage and snack sticks and the temp swings in the MES were killing me. I finally bought an Auber PID and I’m working on rewiring the MES to bypass the controller. I was using @tallbm guide and our wire configurations are a bit different. Can anyone tell me which wires on mine are plug hot, plug neutral, rollout limit/heating element hot, and the heating element neutral wire? The thing that is tripping me up is that his white wire is going into the relay at the top while my black wire is going there. Any help is greatly appreciated. Thanks in advance and I apologize if this has already been covered for the gen 3 with my wiring configuration.
I’ve been reading this forum for the past few months and it has helped me dial in my MES 40. I smoke a lot of summer sausage and snack sticks and the temp swings in the MES were killing me. I finally bought an Auber PID and I’m working on rewiring the MES to bypass the controller. I was using @tallbm guide and our wire configurations are a bit different. Can anyone tell me which wires on mine are plug hot, plug neutral, rollout limit/heating element hot, and the heating element neutral wire? The thing that is tripping me up is that his white wire is going into the relay at the top while my black wire is going there. Any help is greatly appreciated. Thanks in advance and I apologize if this has already been covered for the gen 3 with my wiring configuration.
