Hi everyone. New to the group but have been snooping around for a little. Started an octagonal reverse build today. Everything is 3/16” thick. 10” sides except the verticals sides are 12”. FB is 18x18x23. Should come to around 85ish gallons. Will post more as build continues. Novice welder so please be easy
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
36” octagonal build
- Thread starter benv909
- Start date
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
