Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Alright so I have a 300 gallon fuel tank in the works of becoming a cooker. I have gotten this far does anyone have any suggestions? The lid has bowed a bit give me some ideas boys
Add some metal under the lid then some good latches, the lid will stay in place after a few hot runs and you can add gasket if needed, the 1 I am building I layed down, I cut center to center for the door.
Tack 1 inch flat around the lid and beat into shape if it doesn't bend heat specific areas with torch and shape don't get a large area to hot or it'll warp again. When cutting a door allow to cool in between cuts.